Sharp MX-M4070 User Manual - Page 35

BEFORE USING THE MACHINE►BEFORE USING THE MACHINE Function Custom Mode Eco Mode As soon as the remote job is finished, On On enter Auto power shut off mode. Sleep Mode Power Level Low Power Low Power Eco Scan On On (All Modes Except Copy) Each Energy Save settings in System Settings is not applied when Custom/Eco mode is used. To set mode settings "Settings (administrator)" → select [System Settings] → [Energy Save] → [Eco Setting] → [Mode Setting]. AUTO POWER SHUT-OFF MODE This mode turns off the power to the operation panel and the fusing unit, and makes the machine wait in the lowest power consumption state. Auto Power Shut-Off Timer will activate when the set duration of time elapses in waiting status without executing a job. Compared to preheat mode, the power-saving rate is considerably higher but the wakeup time is longer. The [Power Save] button blinks when the machine is in Auto Power Shut-Off Timer. Auto Power Shut-Off Timer is also activated by pressing the [Power Save] button while the [Power Save] button is not lit. This mode is cleared when print data is being received, fax data is being output, or when the [Power Save] button is pressed while it is blinking. [Power Save] button/indicator To set Auto Power Shut-Off Timer: In "Settings (administrator)", select [System Settings] → [Energy Save] → [Eco Setting] → [Auto Power Shut-Off]. A message appears 15 seconds before Auto Power Shut-Off Mode is entered. To close the message and continue normal operation, tap the [Continue] button. The message appears again 15 seconds before the end of the extension of normal operation time. If no action is taken within 15 seconds after the message appears, the machine enters auto power shutoff mode. To set display of the message: In "Settings (administrator)", select [System Settings] → [Energy Save] → [Eco Setting] → [Display Message When Extending Transition Time to Preheat/Auto Power Shut-Off Mode]. 1-32