Sharp MX-M4070 User Manual - Page 457

FACSIMILE►BASIC TRANSMISSION METHODS AUTOMATIC REDUCTION OF THE TRANSMITTED IMAGE If the width of the transmitted image is larger than the width of the paper in the receiving machine, the image will be automatically reduced to fit the receiving machine's paper width. Example: Reduced sizes and reduction ratios Transmitted image width Receiving machine's paper width Reduced size Scaling 11" x 17" (A3) 11" x 17" (A3) B4 B4 B4 8-1/2" x 11" (A4) A4R 8-1/2" x 11" (A4) A4R 1:0.8 1:0.7 1:0.8 To cancel the Auto Reduction Sending setting: In "Settings", select [System Settings] → [Image Send Settings] → [Fax Settings] → [Send Settings] → [Auto Reduction Sending Setting]. If this setting is disabled, the image will be sent at full size and part of the image may be cut off. TRANSMITTABLE ORIGINAL SIZES The following original sizes can be transmitted. Minimum original size Maximum original size Using the automatic document feeder Using the document glass * A long original can be transmitted. 5-1/8" (height) x 5-1/2" (width) (131 mm (height) x 140 mm (width)) - 11-5/8" (height) x 39-3/8" (width) (297 mm (height) x 1000mm (width))* 11-5/8" (height) x 17" (width) (297 mm (height) x 432 mm (width)) THE SIZE OF THE PLACED ORIGINAL When a standard size original is placed, the original size is automatically detected and displayed in "Scan Size" on the base screen. ► AUTO DETECTION (page 4-41) Standard sizes are sizes that the machine can automatically detect. The standard sizes are set in "Original Size Detector Setting" in setting mode. When the automatic original detection function is operating and the original (of inch or non-standard size) is placed, the closest size may be displayed or the original size may not appear. In this event, manually set the correct original size. ► SPECIFYING THE ORIGINAL SCAN SIZE IN PAPER SIZE (page 4-42) ► SPECIFYING THE ORIGINAL SCAN SIZE USING NUMERIC VALUES (page 4-43) To specify the size that the machine can automatically detect: In "Settings (administrator)", select the group of detected original sizes in [System Settings]→ [Common Settings] → [Device Control] → [Original Size Detector Setting]. List of original size detector settings ► Detectable original sizes (page 1-122) 4-24