Sharp MX-M4070 User Manual - Page 826

SYSTEM SETTINGS►SYSTEM SETTINGS Common Settings Device Control Various devices mounted on the machine can be set. Paper Type for Auto Paper Selection The paper types* that the Auto Paper Selection function will select can be specified. Select one of the following settings: • Plain 1 • Plain 2 • Recycled The Auto Paper Selection function will not select any paper types other than the paper types specified with this setting. * The paper type set for each paper tray by selecting [System Settings] in "Settings" → [Paper Tray Settings]. Tandem Connection Setting When two machines are used as network printers using TCP/IP protocol, use this setting to configure the port number and IP address of the machine used as the tandem client machine. Disabling of Master Machine Mode To prohibit tandem transmission, enable this setting. (Normally this setting is not necessary.) Disabling of Client Machine Mode To prohibit tandem reception, enable this setting. (Normally this setting is not necessary.) • To use the tandem function when user authentication is enabled, the same login name and password must be used on both the master machine and client machine. If the same login name and password are not used, the page count may not be added to the appropriate user count or only the master machine may print. • The factory default setting for the port number is [50001]. Unless you experience difficulty with this setting, do not change the port number. Detect Standard in Auto Color Mode When the color mode is set to auto in scanner mode, the discrimination point for detecting whether originals are color or black and white can be set to one of 5 levels. When set to [Closer to B/W ], the originals are easier to recognize as black and white. When set to [Closer color], the originals are easier to recognize as black and white. Total Setting for Finish Select the finish setting. Set whether finishing positions are specified on the specified paper or on the original. Plain Paper Weight Settings These are used to control the toner fusing temperature according to the weight of the paper. These settings apply to plain paper, recycled paper, punched paper, pre-printed paper, letterhead paper, colored paper, and user type paper. You can select "16 to 23 lbs." or "23+ to 28 lbs." ("60g/m2 to 89g/m2" or "90g/m2 to 105g/m2"). This can only be set on the machine's operation panel. Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper that is outside the range with the paper in the tray. When settings are changed, the changes will take effect after the machine is restarted. To restart the machine, see "TURNING ON THE POWER (page 1-11)". Data List To specify [One Sided] or [Two Sided] printing in Data List. Disabling of Duplex This is used to disable 2-sided printing, such as when the duplex module malfunctions. 7-72