Sharp MX-M4070 User Manual - Page 831

SYSTEM SETTINGS►SYSTEM SETTINGS IPv4 Settings When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine. DHCP Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not necessary to manually enter an IP address. • If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing will not be possible. • If the machine is used on a TCP/IP network, be sure to enable the "TCP/IP (page 7-79)" below. IPv4 Address Enter the IP address of the machine. Subnet Mask Enter the IP subnet mask. Default Gateway Enter the default gateway address. DNS Settings Primary Server Enter the IP address of primary DNS server. Secondary Server Enter the IP address of secondary DNS server. Domain Name Enter the domain name where the selected DNS server exists. SMTP Settings Primary Server Enter the IP address or the host name of the primary SMTP server. Sender Name Enter the sender name. Sender Address If data transmission has failed, the undelivered e-mail may be returned from the server. Enter an e-mail address (a single address only) to receive such undelivered mails. Usually, enter the e-mail address of system administrator. Enable SSL If is selected, the SMTP-over-TLS encryption communication can be used by STARTTLS command. This requires the server to support the STARTTLS command. To allow SSL communication, set the "Port Number" to the same port number as the normal SMTP. SMTP Authentication If is set, the SMTP server authentication is carried out. User Name Enter the user name. 7-77