Cisco SFS7000P-SK9 Command Reference - Page 116

fc srp initiator Chapter 3 Fibre Channel Commands fc srp initiator To configure an initiator-normally a SAN-attached host but in IB terms a SRP host combined with a Server Switch-to communicate with a Fibre Channel SAN across a Fibre Channel gateway on your Server Switch, enter the fc srp initiator command in Global Configuration mode. To deny SAN access to the SRP host, to delete an initiator from the running configuration, or to reconfigure the description of the initiator to an empty string, use the no form of this command. fc srp initiator guid extension {auto-bind | bootup target target-wwpn lu logical-unit | description descr | discover-itl | pkey pkey-value | wwnn wwnn-value} no fc srp initiator guid extension [description] Syntax Description guid extension auto-bind bootup target target-wwpn lu logical-unit description descr discover-itl pkey pkey-value Global unique identifier (GUID) of the SRP host. Note The GUID of your SRP host appears printed on the HCA in your server, and you can use host driver utilities to view the GUID. For more information, refer to the Host Channel Adapter Installation Guide. GUID extension of the SRP host. 1. Creates the initiator entry in the configuration file and binds the host to a world-wide node name (WWNN) that your Server Switch generates internally to uniquely identify the host. 2. Creates virtual ports for this initiator on every possible physical FC gateway port on your Server Switch. FC devices use these virtual ports to communicate with the initiator. Configures the SRP host to boot from a Fibre Channel logical unit (LU). Specifies the world-wide port name (WWPN) of the port of the FC storage device that stores image that you want the initiator to boot. WWPN of the port of the FC storage device that stores image that you want the initiator to boot. Specifies the logical unit (LU) that stores image that you want the initiator to boot. Logical ID of the LU that stores image that you want the initiator to boot. (Optional) Assigns an alphanumeric ASCII description string to the initiator. Alphanumeric ASCII description string to assign to the initiator. Discovers initiator-target-LUN (ITL) combinations and adds them to your configuration file. Targets refer to SAN storage devices, and LUNs refer to the logical units within SAN storage devices. Assigns a partition key (P_key) to the initiator. Note Your Server Switch does not currently support partition keys for SRP. 16-bit partition key to assign to the initiator. Assign multiple partition keys by appending a colon, then the next key (aa:aa:bb:bb:cc:cc:dd:dd). Cisco SFS 7000 Series Product Family Command Reference Guide 3-2 OL-9163-02