Cisco SFS7000P-SK9 Command Reference - Page 46

cdp run Chapter 2 Administrative Commands cdp run To enable Cisco Discovery Protocol (CDP), use the cdp run command in global configuration mode. To disable CDP, use the no form of this command. cdp run no cdp run Syntax Description This command has no arguments or keywords. Defaults Disabled Command Modes Global Configuration (config) mode. Usage Guidelines Platform Availability: Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module for IBM BladeCenter Privilege Level: Unrestricted and general read-write user. CDP is enabled by default, which means the Cisco IOS software will receive CDP information. CDP also is enabled on supported interfaces by default. To disable CDP on an interface, use the no cdp run interface configuration command. Note Because ODR (o- demand routing) uses CDP, the cdp enable, cdp timer, and cdp run commands affect the operation of the router odr global configuration command. For more information on the router odr command, see the Cisco IOS IP Command Reference, Volume 2 of 3: Routing Protocols document. Note CDP runs by default when a chassis boots, but CDP is only learning in this mode. If any neighbors are advertising, CDP will identify them. Examples The following example starts CDP advertising on your chassis: SFS-7000P(config)# cdp run The following example starts CDP advertising on your chassis and specifies the CDP timer interval: SFS-7000P# configure SFS-7000P(config)# cdp run SFS-7000P(config)# cdp timer 10 2-16 Cisco SFS 7000 Series Product Family Command Reference Guide OL-9163-02