Cisco SFS7000P-SK9 Command Reference - Page 157
bridge-group
UPC - 882658093029
View all Cisco SFS7000P-SK9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Chapter 5 IP Commands bridge-group bridge-group To create and configure bridge groups, enter the bridge-group command in Global Configuration mode or Ethernet Interface Configuration submode. To remove bridge groups or attributes of bridge groups, use the no form of this command. bridge-group bridgegroupID {broadcast-forwarding | eth-next-hop ip-address [dest dest-addr dest-mask] | ib-next-hop ip-address [dest dest-addr dest-mask] | name "name-string"| subnet-prefix prefix length | loop-protection {one | two} | multicast | fail-over-priority priority | redundancy-group group} bridge-group bridgegroupID [pkey partition-key] no bridge-group bridgegroupID [broadcast-forwarding | eth-next-hop | ib-next-hop | loop-protection {one | two} | multicast | redundancy-group group] no bridge-group bridgegroupID [pkey | subnet-prefix prefix length] Syntax Description bridgegroupID broadcast-forwarding eth-next-hop ip-address ib-next-hop loop-protection one two multicast name name-string subnet-prefix prefix length fail-over-priority priority redundancy-group group pkey partition-key dest dest-addr dest-mask Bridge group to create or reconfigure. (Optional) Enables broadcast forwarding for the bridge group. (Optional) Identifies the next-hop IP address connected to the ethernet gateway. (Optional) Next-hop IP address (Optional) Identifies the next-hop IP address connected to the IB switch. (Optional) Specifies the type of loop protection for the bridge-group. Specifies type one loop protection (ARP packet painting enabled). Specifies type two loop protection (ARP packet painting disabled). (Optional) Enables IP-V4 multicast forwarding for the bridge group. Assigns an ASCII text string identifier to the bridge group. ASCII text string identifier for the bridge group. (Optional) Assigns a subnet to the bridge-group. (Optional) Subnet to assign to the bridge group. (Optional) Length, in bits, of the subnet mask to assign to the bridge group. Specifies the failover priority of the bridge group. Integer value (1 - 255), where the lower the integer the higher the priority. (Optional) Assigns the bridge group to a redundancy group. (Optional) Redundancy group to which you want the bridge group to belong. (Optional) Specifies a partition key to assign to the bridge group. Partition key to assign to the bridge group. (Optional) Specifies the destination subnet. (Optional) Address of the destination subnet. (Optional) Mask of the destination subnet. Defaults OL-9163-02 This command has no default settings. Cisco SFS 7000 Series Product Family Command Reference Guide 5-3