Cisco SFS7000P-SK9 Command Reference - Page 176

show boot-config Chapter 6 Show Commands show boot-config To display the active system image that runs when your Server Switch boots, enter the show boot-config command in User Exec mode or Privileged Exec mode. show boot-config Syntax Description This command has no arguments or keywords. Defaults No default behavior or values Command Modes User Execute mode, Privileged Execute mode. Usage Guidelines Platform Availability: Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module for IBM BladeCenter Privilege Level: General read-only user. The show boot-config command displays the image that initializes chassis firmware and configures the interfaces. This command lists the files that were used to bring up the system, the files to use the next time the system reboots, and the backup files to use in the event that the primary boot files are not available. Command Output: Table 6-4 describes the fields in the show boot-config command output. Table 6-4 show boot-config Command Field Descriptions Field slot-id sw-version last-image-source primary-image-source Description Slot identifier of the controller card in use. Version of the software image that initialized chassis components. Directory name of the active system image used to initialize chassis components. Name and directory location of the active system image to use to initialize chassis components the next time the system boots. 6-10 Cisco SFS 7000 Series Product Family Command Reference Guide OL-9163-02