Cisco SFS7000P-SK9 Command Reference - Page 392

Chapter 7 Diagnostic Commands test test Specify a diagnostic test to run with the test command in appropriate Diagnostic Configuration submode. test {echo | int-loopback | ext-loopback | led | self-test} Note The SFS 7000 does not support external loopback tests for InfiniBand interfaces. Table 7-8 describes the different tests that you can run and the interfaces or cards on which you can run them. Syntax Description echo int-loopback ext-loopback led self-test ext-cable Echo test (Fibre Channel gateway only). Internal loopback test (unsupported). External loopback test (Fibre Channel gateway only). LED test. Self test. External cable test (unsupported). Defaults This command has no default settings. Command Modes Fibre Channel Interface Diagnostic Configuration (config-diag-if-fc) submode, Ethernet Interface Diagnostic Configuration (config-diag-if-en) submode, InfiniBand Interface Diagnostic Configuration Usage Guidelines Platform Availability: Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module for IBM BladeCenter Privilege Level: Read-write user. Examples The following example specifies a LED test to run on card 11 when the start command executes: SFS-7000P (config-diag-card-11)# test LED Related Commands diagnostic show interface ethernet show interface fc show interface gateway start stop 7-226 Cisco SFS 7000 Series Product Family Command Reference Guide OL-9163-02