Cisco SFS7000P-SK9 Command Reference - Page 90

reload Chapter 2 Administrative Commands reload To reboot your Server Switch, enter the reload command in Privileged Exec mode. reload [no-failover] Syntax Description no-failover (Cisco SFS (Optional) Forces a Cisco SFS 3012 to run from the same controller card 3012 only) when it reboots. By default, Cisco SFS 3012 Server Switches swap active controller cards when they reboot. Defaults This command has no default settings. Command Modes Privileged Execute mode. Usage Guidelines Platform Availability: Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module for IBM BladeCenter Privilege Level: General read-write user. At stages of chassis and interface setup, you need to reinitialize chassis firmware or restore interface card configurations. Use the reload command because it allows the chassis to close files and prepare for shutdown. The reload command brings down the entire Server Switch and restarts all of the cards in the Server Switch. The Server Switch prompts you to verify the reload. If you have not already saved configuration changes, and the Server Switch detects the changes, it prompts you to save. To store the new configuration as the startup configuration, enter yes at the prompt. To store the configuration elsewhere under a different file name, enter the new file name and press Enter. The system reinitializes itself and then loads the active system image and the startup configuration file. Wait a few minutes and attempt to log onto the chassis. Note If your Server Switch includes a second controller card, the CLI will prompt you to save changes to the backup controller as well as to the primary controller. Examples The following example reloads the Server Switch: SFS-7000P# reload System configuration has been modified. Save? [yes(default)/no/*.cfg] yes Proceed with reload? [confirm] SFS-7000P# Connection to host lost. # 2-60 Cisco SFS 7000 Series Product Family Command Reference Guide OL-9163-02