Cisco SFS7000P-SK9 Command Reference - Page 334
Maximum Transmission Unit for the InfiniBand
UPC - 882658093029
View all Cisco SFS7000P-SK9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 334 highlights
show interface ib Chapter 6 Show Commands Table 6-69 show interface ib Command Field Descriptions (continued) Field Description type Identifies the type of the InfiniBand card. Supported cards are ib1xTX, ib1xFX, ib4xTX, ib4xFX, and ib4xTXP. This field is set by the type command. desc Description of the port, in slot#/port# format. The number in parentheses serves as the SNMP identifier. last-change Time at which the InfiniBand port configuration was last changed. mtu Maximum Transmission Unit for the InfiniBand port. Used to configure the MTU size of IP network traffic. auto-negotiate supported (select Server Switches) Displays "yes" if the port supports auto-negotiation or "no" if the port does not support auto-negotiation. auto-negotiate (select Server Switches) Indicates if the InfiniBand port on the interface card is configured to automatically negotiate connection parameters when it connects with an InfiniBand device. If auto-negotiation is enabled, the connection speed is determined at the time of connection. If the device does not support auto-negotiation, this field still displays a value, but the value does not apply. The value is enabled or disabled. The default is disabled. This field is set by the auto-negotiate command. admin-status Indicates if you have enabled the port for configuration and use. The value of this field may be up or "down." The default is "down." The field is set by the shutdown command. oper-status Indicates if the port is physically ready for configuration and use. The value of this field may be up or "down." If this field is down but the admin-status is up, check that the InfiniBand interface card is securely seated in the slot and a cable is attached between the port and the target InfiniBand host. admin-speed (select Server Switches) Indicates the speed administratively assigned to the InfiniBand port. You can configure this setting with the speed command. oper-speed (select Server Switches) Indicates the maximum speed of the InfiniBand port, based upon the attached InfiniBand cable and polling the connected InfiniBand device. 6-168 Cisco SFS 7000 Series Product Family Command Reference Guide OL-9163-02