Cisco SFS7000P-SK9 Command Reference - Page 390

Chapter 7 Diagnostic Commands stop stop To end a diagnostic test, enter the stop command in the appropriate Interface DiagnosticConfiguration submode. stop Syntax Description This command has no arguments or keywords. Defaults This command has no default settings. Command Modes Fibre Channel Interface Diagnostic Configuration (config-diag-if-fc) submode, Ethernet Interface Diagnostic Configuration (config-diag-if-en) submode, or Card Interface Diagnostic Configuration (config-diag-if-card) submode, Card Diagnostic Configuration submode, (config-diag-card), Chassis Diagnostic Configuration submode (config-diag-chassis), Fan Diagnostic Configuration submode (config-diag-fan), Power Supply Diagnostic Configuration submode (config-diag-power-supply), Rack Locator Diagnostic Configuration submode (config-diag-rack-locator), InfiniBand Interface Diagnostic Configuration submode (config-diag-if-ib) Usage Guidelines Platform Availability: Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module for IBM BladeCenter Privilege Level: Fibre Channelread-write user. Examples The following example stops the test running on Fibre Channel port 4/1: SFS-7000P(config-diag-if-fc-4/1)# stop The following example stops the test running on card 6: FS-7000P (config-diag-card-6)# stop Related Commands diagnostic show interface ethernet show interface fc show interface gateway start test 7-224 Cisco SFS 7000 Series Product Family Command Reference Guide OL-9163-02