Cisco SFS7000P-SK9 Command Reference - Page 188
show card-inventory
UPC - 882658093029
View all Cisco SFS7000P-SK9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
show card-inventory Chapter 6 Show Commands show card-inventory To display the system resources and image data of interface cards, enter the show card-inventory command in User Execute mode or Privileged Execute mode. Note The show card-inventory command only displays cards with an oper-status of up. show card-inventory [card-selection | all] Syntax Description card-selection all (Optional) Card, list of cards, or range of cards to view. (Optional) Displays resources and data of all cards in the chassis. Defaults The show card-inventory defaults to show card-inventory all. Command Modes User Execute mode, Privileged Execute mode. Usage Guidelines Platform Availability: Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module for IBM BladeCenter Privilege Level: General read-only user. Each interface card is a system in itself. The following comprise system resources: • available and used memory • available and used flash memory • active system image on the interface card • CPU name and version The active system image should match the active image that runs on the controller card. Occasions may occur when you update the system image on the controller but not on an interface card, such as when you swap interface cards between chassis or update the system image on the controller when an interface card goes down. Disk space may be an issue if you try to update the system image on the controller but cannot propagate this data to the interface card because the interface card has no free space. The CPU description may be requested by support personnel in the event you experience difficulties with a controller or an interface card. 6-22 Cisco SFS 7000 Series Product Family Command Reference Guide OL-9163-02