Yamaha CS1D Owner's Manual - Page 144

Chapter 6. Insert and direct out This chapter explains how external devices such as effect processors can be inserted into a specific channel, and how the signal of an input channel can be directly output from a desired output jack. Insert An external device such as an effect processor can be inserted in an input channel/output channel of the PM1D system. Connecting the external device to be inserted To insert an external device into a specific channel, you will use the output jack and input jack of an output unit as the insert out/insert in jacks respectively. The following diagram shows typical connections for insertion. • Example connections for insertion 1 DA card LMY4-DA 1 2 3 4 5 6 7 8 AO8 analog output unit OUTPUT UNIT NO. INPUT SELECTOR A B POWER ON/ OFF ANALOG OUTPUT BOX DIGITAL I/O CARD MODEL MY8-TD • Example connections for insertion 2 Digital I/O card OUT DIO8 digital input/output unit I/O UNIT ID PORT B SELECTOR 5-8 1-4 POWER ON/ OFF IN L R 88 Effect processor 1 2 3 4 5 6 7 8 AI8 analog input unit AD card LMY4-AD INPUT UNIT NO. PHANTOM MASTER ON +48V OFF POWER ON/ OFF ANALOG INPUT BOX DIGITAL IN DIGITAL OUT 88 Effect processor If an external digital device is inserted via a digital I/O card as shown in "Example connections for insertion 2," the word clocks of the PM1D system and the digital device must be synchronized. Normally, we recommend that you set the digital device as the slave, so that it will synchronize to the word clock of the PM1D. (For details on setting it to slave mode, refer to the manual for your device.) 85