Yamaha CS1D Owner's Manual - Page 293

CS1D Reference Manual (Hardware) By clicking one of the above buttons, you can use the DCA faders to control the graphic EQ. In this case, the [FADER STATUS] switches located above the DCA GROUP block on the CS1D top panel will function as band select switches for the bands of the graphic EQ, as shown in the following illustration. (The LEDs will light to indicate the [FADER STATUS] switches that can be used as band select switches.) In this case, the FADER STATUS [IN] switch and the FADER STATUS [37-48] switch will have no effect. IN 1-12 1.60k-20.0k 13-24 200-2.50k 25-36 20-250 37-48 DCA OFF FADER STATUS 10 11 12 (2) Switching on-screen In the ASSIGN TO DCA FADERS buttons located in the lower right of the screen, click the desired button. • 1.60 k - 20.0 k button The twelve bands from 1.6 kHz-20 kHz will be assigned to the DCA faders. • 200-2.50 k button The twelve bands from 200 Hz-2.5 kHz will be assigned to the DCA faders. • 20-250 button The twelve bands from 20 Hz-250 Hz will be assigned to the DCA faders. IN 1-12 1.60k-20.0k 13-24 200-2.50k 25-36 20-250 37-48 DCA OFF FADER STATUS 10 11 12 7. Operate DCA faders 1-12. The corresponding frequency bands will be boosted or cut. 8. If you wish to use the DCA faders to control other bands, repeat steps 7-8. 9. To stop using the DCA faders to control the graphic EQ, press the FADER STATUS [DCA] switch on the CS1D. Alternatively, click OFF in the ASSIGN TO DCA buttons of the GEQ PARAMETER screen. The [FADER STATUS] switches of the CS1D will return to their original state. To once again assign the graphic EQ to the DCA faders, click one of the ASSIGN TO DCA buttons in the GEQ PARAMETER screen. When you exit the GEQ PARAMETER screen, assignments to the DCA faders will be forcibly canceled, and the DCA faders will return to their previous state. 76