Yamaha CS1D Owner's Manual - Page 176
Controls and functions of the CUE Using the Cue function, MONITOR A screen MON/CUE function
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
Chapter 10. Monitor Controls and functions of the CUE section Operations for the Cue/Solo function are performed in the CUE section of the MASTER block or in the display (MON/ CUE function CUE/SOLO screen). The controls and functions of the CUE section are explained below. [INPUT AFL] switch and LED This switch selects the output location of the signal that is sent to the CUE bus when a [CUE] switch of an input channel (input channel, ST IN channel) is pressed. [SOLO] switch and LED This selects either CUE mode (LED dark) or SOLO mode (LED blinks) as the monitoring method for the [CUE] switches. Press and hold this switch more than 2 seconds to set the SOLO mode CUE ACTIVE [INPUT]/[DCA]/[OUTPUT] LEDs These LEDs indicate the monitoring status. If even one [CUE] switch is currently on, the LED for its group will light. [LAST CUE] switch and LED This switch selects either LAST CUE mode (LED lit) or MIX CUE mode (LED dark) as the operation when the [CUE] switch is pressed for two or more channels. [CUE OUT LEVEL] volume This knob sets the output level of the signal output from the CUE OUT jacks. [OUTPUT PFL] switch and LED This selects the location in the signal route at which the signal will be monitored when you press the [CUE] switch of an output channel (MIX channel, MATRIX channel, STEREO A/B channel). [DCA PRE PAN] switch and LED This switch selects the location in the signal route at which the signal will be monitored when a [CUE] switch in the DCA GROUP block is used to monitor a DCA group to which input channels are assigned. Using the Cue function Here's how to use the [CUE] switch of the desired channel/DCA group to monitor the cue signal. [Procedure] 1. In the LCD FUNCTION ACCESS block, press the [MON/CUE] switch several times to access the following MONITOR A screen. • MONITOR A screen (MON/CUE function) LCD FUNCTION ACCESS block [MON/CUE] switch 2. Make sure that the CUE INTERRUPTION button located at the right edge of the screen is turned on. The CUE INTERRUPTION button is an on/off switch for the interrupt from the cue signal of the [CUE] switch. Be aware that if this button is off, pressing a [CUE] switch will not affect MONITOR OUT jacks A. 117