Yamaha CS1D Owner's Manual - Page 231
ST IN [MIX] encoder and LEDs, ST IN MIX [ON] LED, ST IN [PAN] encoder and LEDs, When LCR=off, When
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
CS1D Reference Manual (Hardware) 1 L STATUS R 2 MIX 3 0 10 ON 4 PAN L R 6 5 TO ST +48V INS A B 7 9 INPUT 8 0 GAIN A +10 -68 L CLIP R 1 ST IN STATUS [L]/[R] LEDs These LEDs indicate whether this ST IN channel module currently shows the right or the left channel. When the [L] LED is lit, the module shows the status of the left channel. When the [R] LED is lit, the module shows the status of the right channel. Hint The two-channel signal that is patched to the ST IN channel will be processed as a pair, all parameters will be linked except for the head amp settings (A/B channel selection, phantom power on/off, gain adjustment), and pan and delay. 2 ST IN [MIX] encoder and LEDs When a VARI type MIX bus is selected, this encoder sets the send level of the signal that is sent from the ST IN channel to that MIX bus. The range is - ∞ dB - +10 dB, and the approximate current value is shown by the perimeter LEDs. When the LED for the ® mark is lit, the level is nominal (0 dB). However if a FIX type MIX bus is selected, the ST IN [MIX] encoder will have no effect, the LEDs will remain dark even if the encoder is operated Hint To select the MIX bus that will be the send destination of the ST IN channel, use the MIX OUTPUT block MIX [SEL] switch, or the SELECTED OUTPUT CHANNEL block CHANNEL SELECT [▼/ DEC]/[▲/INC] switches. 3 ST IN MIX [ON] LED This indicates the on/off status of the signal that is sent from the ST IN channel to the currently selected MIX bus. (The LED will light when on.) The on/off setting can be switched from the console in the SELECTED INPUT CHANNEL block, or in the display (PAN/ROUTING function CH to MIX screen/MIX ASSIGN screen). You can set the FADER [FLIP] switch in the SELECTED INPUT CHANNEL block to exchange (flip) the function of the ST IN [MIX] encoder (2) and the ST IN fader (H). (→p.36) 4 ST IN [PAN] encoder and LEDs This encoder sets the panning of the signal that is sent from the ST IN channel to the STEREO bus. The approximate current setting is shown by the perimeter LEDs. When the LED at the ▲ mark is lit, the pan is at the center. As shown below, the perimeter LEDs will light differently, depending on whether LCR mode (a function that allows three-channel playback with a CENTER channel added to the L/R channels) is on or off. (LCR mode can be turned on/off in the PAN/ROUTING function LCR screen.) • When LCR=off PAN L R • When LCR=on PAN L R PAN L R PAN L R PAN L R PAN L R Hint This parameter can be adjusted independently for left and right channels. 5 ST IN [TO ST] switch and LED This is an on/off switch for the signal that is sent from the ST IN channel to the STEREO bus. (The LED will light when this is on.) This switch does not affect the signal that is sent from the ST IN channel to the MIX buses. 6 ST IN [+48V] LED This LED will light if an AD card with head amp is patched to the ST IN channel, and the phantom power is on. This will be dark if a different type of card is patched, or if phantom power is off. Hint This parameter can be set independently for left and right channels. 14