Yamaha CS1D Owner's Manual - Page 178
Using the Solo function, In the SOLO SAFE of the CUE/SOLO
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
Using the Solo function Here's how to use the Solo function of the PM1D. [Procedure] 1. Use the [LAST CUE] switch of the CUE section to select either LAST CUE mode ([LAST CUE] switch on) or MIX CUE mode ([LAST CUE] switch off) as the mode of operation when two or more [CUE] switches within the same group are pressed. 2. Turn on the [SOLO] switch of the CUE section for two seconds or longer. Solo mode will be selected. In Solo mode, only the signal of the channel/DCA group whose [CUE] switch was pressed will be output to the MIX, MATRIX, and STEREO buses. The same signal can also be monitored from MONITOR OUT jacks A, the PHONES MONITOR A jack, and the CUE OUT jacks. 3. If you wish to exclude only a specific channel from the Solo operation, press the [MON/CUE] switch (located in the LCD FUNCTION ACCESS block) several times to access the following CUE/SOLO screen. LCD FUNCTION ACCESS block [MON/CUE] switch • CUE/SOLO screen (MON/CUE function) Chapter 10. Monitor 4. In the SOLO SAFE section of the CUE/SOLO screen, select the channel(s) that you wish to exclude from the Solo operation. (You may select more than one.) Channels that are selected in the SOLO SAFE section will not be muted in Solo mode. For example, this is a convenient way to avoid soloing channels that must not be soloed accidentally, such as the main STEREO channel or MIX channels that are sending signals to an external recorder. Each button corresponds to the following channels. • INPUT 1-96 {1-48}. Input channels 1-96 {1-48} • ST IN 1-8 {1-4} ....... ST IN channels 1-8 {1-4} • MIX 1-48 MIX channels 1-48 • MATRIX 1-24.......... MATRIX channels 1-24 • STEREO A/B STEREO A/B channels 5. Turn on the [CUE] switch of the desired channel/ DCA group. Only the signal of the corresponding channel/DCA group will be sent to the various buses, and other channels/DCA groups will be muted. The same signal will also be output from MONITOR OUT jacks A, the PHONES MONITOR A jack, and the CUE OUT jacks. 6. To defeat Solo, press the currently-on [CUE] switches once again. Hint When you press the [LAST CUE] switch to change from LAST CUE mode to MIX CUE mode (or vice versa), the previously-valid cue (solo) will be cancelled. Normally, cue/solo operations can be performed independently of the scene memory. However if you recall a scene that causes a channel to switch from monaural to paired, both channels will be turned on if either of the two channels had been set to Cue/Solo On until then. 119