Yamaha CS1D Owner's Manual - Page 146

4. In the LCD FUNCTION ACCESS block, press the INPUT [PATCH] switch several times to access the following INSERT/DIRECT OUT screen (IN PATCH function). In the INSERT/DIRECT OUT screen (IN PATCH function) you can switch insertion on/off for each input channel. Here you can also select the insert I/O point (the position at which the external device is inserted), and the direct out point (the position from which direct output is taken). Hint You can also turn insert on/off in the SELECTED INPUT CHANNEL block. Chapter 6. Insert and direct out • INSERT/DIRECT OUT screen (IN PATCH function) Number of the input channel Turn insert on/ off for each Short name of the input channel. channel Specify the insert I/O point for each channel. Specify the direct out point for each channel Hint You can also access the INSERT/DIRECT OUT screen (IN PATCH) by clicking the INSERT/DIRECT POINT tab in step 3. 5. Click the INS. button for the desired channel to turn it on. Insert will be enabled for the corresponding channel. 6. Click one of the following buttons to select the desired INSERT I/O POINT. • PRE EQ Immediately before the EQ • POST EQ Immediately after the EQ • PRE COMP.........Immediately before the com- pressor • PRE DELAY ........Immediately before the delay • PRE FADER........Immediately before the fader 7. In the LCD FUNCTION ACCESS block, press the INPUT [HA/INSERT] switch. The IN HA/INSERT function screen will appear. This contains mainly input card preamp settings (A/ B selection, gain adjustment, etc.). • IN HA/INSERT function screen 87