Yamaha CS1D Owner's Manual - Page 196
Controlling a graphic EQ from the DCA faders, In the ASSIGN TO DCA FADERS located
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
on/off, the Q knobs adjust the steepness, and the F knobs adjust the center frequency. • Notch filters Chapter 13. Graphic EQ Hint Notch filters 1-4 are independent of the graphic EQ, and are not affected by the GEQ ON/OFF button. If necessary, you can access the graphic EQ module and use only the notch filters. Controlling a graphic EQ from the DCA faders Here's how to control the desired GEQ module in realtime by using the twelve DCA faders in the DCA GROUP block of the console. When this method is used, the currently selected GEQ module is divided into three frequency bands which are operated individually. [Procedure] 1. In the LCD FUNCTION ACCESS block, press the [GEQ] switch several times to access the GEQ PARAMETER screen. Make sure that the GEQ ON/OFF button is turned on. Also make sure that the corresponding module is inserted into an appropriate channel, and that insertion is enabled for that channel. LCD FUNCTION ACCESS block [GEQ] switch • GEQ PARAMETER screen (GEQ function) Hint Holding down the [SHIFT/GRAB] switch and pressing the [SEL] switch of a channel will display the GEQ if a GEQ has been inserted into that channel. 3. In the LIMIT section located at the right of the faders, specify the control width for the faders. 4. In the ASSIGN TO DCA FADERS section located in the lower right of the screen, click one of the following buttons to select the frequency bands that will be controlled by the DCA faders. Each button corresponds to the following frequency bands. • 1.60k-20.0k button The DCA faders will be assigned to the twelve bands from 1.6 kHz-20 kHz. • 200-2.50k button The DCA faders will be assigned to the twelve bands from 200 Hz-2.5 kHz. • 20-250 button The DCA faders will be assigned to the twelve bands from 20 Hz-250 Hz. 2. Click the MODULE button located in the upper left of the screen, and select the GEQ module that you wish to control. 137