Yamaha CS1D Owner's Manual - Page 210
Specifying the metering points, Input channel metering point
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
Chapter 16. Various settings Specifying the metering points The metering point (the location at which the level is detected) for the level meters on the CS1D console can be specified independently for input channels and output channels. Input channel metering point Here's how to set the metering point for the input levels displayed by the level meters of the INPUT block/ST IN block. [Procedure] 1. In the LCD FUNCTION ACCESS block, press the [METER] switch several times to access the CH 148/STIN 1-4 screen or the CH 49-96/STIN 5-8 screen. {The CH 49-96/STIN5-8 screen is not valid for the 48 CH model.} LCD FUNCTION ACCESS block 2. Use the buttons located at the right of the screen to select the metering point at which the input level will be detected. The following metering points can be selected. • PRE ATT Before the attenuator • PRE GATE.......... Immediately before the internal gate • PRE FADER ....... Immediately before the fader • POST FADER .... Immediately after the fader • POST ON Immediately after the [ON] switch 3. If you want the peak level display of the input channels to be held, turn on the PEAK HOLD button. [METER] switch • CH 1-48/STIN 1-4 screen (METER function) Hint Steps 2 and 3 will affect the following level meters. • Level meters of the INPUT block/ST IN block • Level meters of the SELECTED INPUT CHAN- NEL block • Level meters of the CH 1-48/STIN 1-4 screen and CH 49-96/STIN 5-8 screen However, the METER [PEAK HOLD] switch in the MASTER block of the CS1D will affect only the CLIP LED of the SELECTED INPUT CHANNEL block. The CH 1-48/STIN 1-4 screen and CH 49-96/STIN 5-8 screen show virtual level meters that indicate the input levels of the input channels. In this screen you can also select the metering point for the input channels. 151