Yamaha CS1D Owner's Manual - Page 226
INPUT [SEL] switch and LED, INPUT [NAME] indicator
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 226 highlights
INPUT block * Each of the diagrams shows the example of using the input channel itself as the key-in signal for the compressor. Hint The compressor on/off status and its parameters can be set in the SELECTED INPUT CHANNEL block, or in the display (IN GATE/COMP function COMP PRM screen). G GATE [+]/[THR]/[-] LEDs These LEDs indicate the operating status of the internal noise gate. If the noise gate is turned off, all LEDs will be dark. If the noise gate is turned on, one of the LEDs will light to indicate the currently selected type and operating status of the noise gate. When the noise gate type is GATE Level GATE ATTACK HOLD Key-in signal Output signal Threshold level [-] [THR] [+] [THR] [-] Time When the noise gate type is DUCKING Level DUCKING ATTACK HOLD Key-in signal Output signal Threshold level [-] [THR] [+] [THR] [-] Time * Each of the above diagrams shows the example of using the input channel itself as the key-in signal for the noise gate. Hint The noise gate on/off status and its parameters can be set in the SELECTED INPUT CHANNEL block, or in the display (IN GATE/COMP function GATE PRM screen). H INPUT [SEL] switch and LED This switch selects the input channel to which your operations will apply. The [SEL] LED for the currently selected input channel will light. The channel selected by this switch can be adjusted in the SELECTED INPUT CHANNEL block, and these adjustments will also be reflected in the display. Hint If the selected input channel is part of a pair, the [SEL] LED will blink for the other input channel of the pair. You can also use the [SEL] switch to set/defeat pairing. [Procedure] Using the [SEL] switch to set/defeat pairing 1. For two input channels that can be set as a pair, hold down one of the [SEL] switches and press the other [SEL] switch. The direction in which the channel parameters are copied will depend on the order in which the [SEL] switches are pressed. When creating a pair, the parameters of the channel you pressed first will be copied to the channel that you pressed later, and then the parameters will be linked. For example if you wish to pair CH 1 and CH 2, hold down the CH 1 [SEL] switch and press the CH 2 [SEL] switch. The state of CH 1 will be copied to CH 2. For details on the parameters that are copied/ linked for a pair, refer to "CS1D Reference Manual (Appendices)" (→p.45). If you wish to reset the parameters, do so from the screen. 2. To defeat pairing, hold down the [SEL] switch for one of the paired channels, and press the [SEL] switch for the other channel. I INPUT [NAME] indicator This shows the short name of the input channel. The short name can be input in the display (IN PATCH function NAME screen, etc.). J Meter LEDs These six LEDs indicate the input level of the input channel. The position at which the level is detected can be selected from the following locations: PRE ATT. (before the attenuator), PRE GATE (immediately before the internal noise gate), PRE FADER (immediately before the fader), POST FADER (immediately after the fader), or POST ON (immediately after the [ON] switch). The level detection point can be selected in the display (METER function). The peak level of this meter will not be held even if the PEAK HOLD button is turned on in the display (METER function input meter screen). K [ON] switch and LED This switches the on/off status of the input channel. (This LED will be lit for input channels that are turned on.) If this switch is turned off, no signal will be sent from that input channel to the STEREO bus or MIX buses. 9