Yamaha CS1D Owner's Manual - Page 448

OUT INSERT OUT PATCH OUT EQ OUT CH VIEW MATRIX/ST OUT DCA/MUTE OUT DELAY OUT COMP LED lighting • When LCR=off L R L R • When LCR=on L R L R L R L R 3 CSR (center side ratio) Adjust the level ratio of the CENTER channel relative to the L/R channels. The range is 0.0-1.0. If CSR is set to 0:0, rotating the PAN knob in the MIX TO STEREO section of the MATRIX/ST ROUTING screen will cause the signal levels of the L/R channels to change as shown in LCR response curve 1, below. In this case, the MIX TO STEREO PAN will function as a conventional PAN control, and no signal will be sent to the CENTER channel. LCR response curve 1 MATRIX/ST (matrix/stereo) function 4 Pairing This shows the number and pairing status of the MIX channel. You can also click the heart symbol to set/defeat pairing. Parameters 2-3 will be linked for paired channels. Hint The master level of the CENTER channel is controlled by the fader of the STEREO B block on the CS1D. If necessary, you can also use the internal EQ or compressor of the STEREO B channel to process the signal. One of the output jacks patched to the STEREO B channel will be used as the output jack for the CENTER channel. (If the CENTER BUS CONTROL button is on, the same signal will be output to the L/R channels of STEREO B.) Signal level Signal sent to the L channel Signal sent to the R channel L C R [PAN] encoder If CSR is set to 1.0, rotating the PAN knob in the MIX TO STEREO section of the MATRIX/ST ROUTING screen will cause the signal levels sent to the L/R channels and the CENTER channel to change as shown in LCR response curve 2, below. When the PAN knob in the MIX TO STEREO section is in the center location, the signal level of the CENTER channel will be maximum, and no signal will be sent to the L/R channels. LCR response curve 2 Signal level L C R [PAN] encoder Signal sent to the C channel Signal sent to the L channel Signal sent to the R channel 113