Yamaha CS1D Owner's Manual - Page 406
Mon/cue, Output On/off
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 406 highlights
EFFECT GEQ SCENE MIDI/GPI/TC MON/CUE (monitor/cue) functions • COMM IN Select the input jack that will be the source for the COMM IN signal. When you click the button, a popup window will appear in which you can select the unit number/slot number/channel of the input jack. The input level of the signal is shown by the level meter at the left. If an input card with head amp is selected, this screen will allow you to switch between A/B jacks, turn phantom power on/off, switch between normal/ inverted phase, and adjust the input gain. • GATE Make settings for gating the COMM IN signal. The GATE ON/OFF button switches the gate on/off. By clicking the mini-graph, you can access a screen for setting the parameters. • LEVEL Adjust the output level of the COMM IN signal after passing through the gate. 5 7 8 9 6 0 5 MONITOR MODE These buttons select one of the following four monitoring methods for the MONITOR A output. This is linked with the [L MONO] and [R MONO] switches in the MONITOR section of the CS1D top panel. • STEREO L/R channels will be monitored in stereo. • L-MONO Only the L channel will be monitored in monaural. • R-MONO Only the R channel will be monitored in monaural. • LR-MONO..........The L/R channels will be mixed, and monitored in monaural. 6 DIMMER These buttons temporarily attenuate the levels of the COMM IN and the signal that was being monitored when talkback was ON. The amount of attenuation when the button is turned on can be adjusted by the knobs located immediately below. The range of adjustment is -96 dB - 0dB. When COMM IN or talkback are turned on, a COMM IN or TB symbol will appear in the upper part of the screen. 7 Level meters This is a peak level meter that shows the pre-fader level of MONITOR OUT connector A (i.e., the level before the MONITOR A [LEVEL] volume). The level of the signal that is output from the MONITOR OUT connector will vary depending on the state of the MONITOR A [LEVEL] volume and the [ON] switch. Normally these will indicate the level of the MONITOR A output (the source selected in the MONITOR A SOURCE section). When cue/solo is being used, these will indicate the output level of the cue/solo signal. 8 OUTPUT ON/OFF This button is an on/off switch for the signal that is output from the MONITOR OUT A jacks. This will not affect the output to the MONITOR A PHONES jack. 9 CUE INTERRUPTION This button specifies whether or not the cue/solo signal will be output from the MONITOR OUT A jacks. • When the CUE INTERRUPTION button is on When cue/solo is used, the cue/solo signal will be output from the MONITOR OUT A jacks. (The monitor source selected in the MONITOR A SOURCE section will be ignored.) • When the CUE INTERRUPTION button is off The cue/solo signal will not be output from the MONITOR OUT A jacks at all. (Only the monitor source selected in the MONITOR A SOURCE section will be output at all times.) 0 DELAY Here you can set the delay function provided for the MONITOR/CUE bus output. Use the knob to specify a delay time (0-750 msec) and use the DELAY button to turn the delay on/off. When the DELAY button is on, the MONITOR A and cue signals will be delayed by the specified time. UTILITY SYS/W.CLOCK METER MON/CUE 71