Yamaha CS1D Owner's Manual - Page 272

5 STEREO [INS] LED This LED indicates the insertion on/off status of the STEREO A/B channel. When insertion is on, the switch LED will light, and the insert out/in points specified in the display (OUTPUT PATCH function INSERT PATCH screen) will be enabled. 6 STEREO fader This is a 100 mm fader that adjusts the output level of the STEREO A/B channel. The range is - ∞ dB - +10 dB. If you are using the PM1D system in LCR mode so that the STEREO B channel controls the signal of the CENTER bus, the STEREO B channel fader will control the output level of the CENTER bus. 7 STEREO SAFE [RCL] LED This LED will light if the STEREO A/B channel is in Recall Safe mode (a condition in which the channel will be unaffected by scene recall operations). The parameters of a channel whose LED is lit will not change even if a scene memory is recalled. Recall Safe settings can be made in the SELECTED OUTPUT CHANNEL block or in the display (SCENE function RECALL SAFE screen). 8 STEREO SAFE [MUTE] LED This LED will light if the STEREO A/B channel is in Mute Safe mode (a condition in which the channel will be unaffected by mute group operations). A channel whose LED is lit will not be affected if a mute group to which it belongs is muted. Mute Safe settings can be made in the SELECTED OUTPUT CHANNEL block or in the display (OUT DCA/MUTE function MUTE GROUP ASSIGN screen). 9 STEREO [CUE] switch and LED This switch monitors the STEREO A/B channel. When you press this switch, the PFL (pre-fader listen) or POST ON (after the [ON] switch) signal of the corresponding channel will be sent to the CUE bus, and can be monitored from the CUE OUT jacks, MONITOR OUT jacks A, and PHONES jack. The location of the signal sent to the CUE bus and the monitoring method can be selected from the CUE section of the console, or in the display (MON/ CUE function CUE/SOLO screen). Hint For details on the signal flow of the STEREO A/B channels, refer to the block diagram on page 68. STEREO OUTPUT block 55