Yamaha CS1D Owner's Manual - Page 235
In the ST IN block, press the ST IN [DCA] switch, ST IN [DCA] switch and LEDs
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 235 highlights
CS1D Reference Manual (Hardware) I ST IN [DCA] switch and LEDs This switch assigns the ST IN channel to DCA groups 1-12. When a ST IN channel is assigned to a DCA group, the corresponding LED will light. The LED will blink while you are in the process of making assignments to a DCA group. Hint It is possible to assign a single ST IN channel to multiple DCA groups, as well as to assign multiple ST IN channels to a single DCA group. [Procedure] Assigning a ST IN channel to a DCA group 1. In the DCA GROUP block, press one of the [ASSIGN DCA] switches 1-12 to select a DCA group (1-12). The LED of the selected [ASSIGN DCA] switch will light. If following step 1 you do not perform any action for approximately ten seconds, the [ASSIGN DCA] switch LED will automatically go dark, and the assignment procedure will be terminated. 2. In the ST IN block, press the ST IN [DCA] switch for the ST IN channel that you wish to assign to the above-selected DCA group. While the DCA GROUP block [ASSIGN DCA] switch LED is lit, all of the INPUT [DCA] LEDs assigned to that DCA group will blink. • DCA groups 9-12 can be used for either input channels or output channels. However, it is not possible to assign both inputs and outputs to the same DCA group. For this reason, if an output channel is already assigned to DCA group 9-12, attempting to assign an input channel will cause an error message to be displayed, and you will not be able to do so. • When a scene is recalled, the DCA group data of recall safe channels may be adjusted so that recall safe settings are consistent within DCA groups 9-12. Also when a channel library is recalled, the data recalled to a channel may be adjusted so that settings are consistent within DCA groups 9-12. J SAFE [RCL] LED This LED will light if the ST IN channel has been set to Recall Safe (a state in which the channel is unaffected by scene recall operations). The parameters of a channel for which this LED is lit will not change when a scene memory is recalled. Recall Safe settings can be made in the SELECTED INPUT CHANNEL block or display (SCENE function RECALL SAFE screen). K SAFE [MUTE] LED This LED will light if the ST IN channel has been set to Mute Safe (a state in which the channel is unaffected by mute group operations). A channel for which this LED is lit will not be affected even if a mute group to which it belongs is muted. Mute Safe settings can be made in the SELECTED INPUT CHANNEL block or display (IN DCA/ MUTE function MUTE GROUP ASSIGN screen). L [CUE] switch and LED This switch is used for monitoring the ST IN channel. When this switch is pressed, the POST PAN, PFL (pre-fader listen), or AFL (after-fader listen) signal of the corresponding ST IN channel will be sent to the CUE bus, and can be monitored from the CUE OUT jacks, MONITOR OUT jacks A, and PHONES jack. The location of the signal that is sent to the CUE bus and the monitoring method can be selected on the console in the CUE section of the MASTER block, or in the display (MON/CUE function CUE/SOLO screen). Hint For the signal flow of the ST IN channel, refer to the block diagram on page 38. 18