Yamaha CS1D Owner's Manual - Page 447

Output functions LCR [Function] Make settings for LCR mode to allow three-channel playback, with a CENTER channel added to the L/R channels of the STEREO bus. This function can be used only for MIX channels. ■ Console In the LCD FUNCTION ACCESS block, press the OUTPUT [MATRIX/ST] switch (press repeatedly until the screen shown at the right appears) ■ Display MENU button → OUTPUT MATRIX/ST button → LCR tab [Screen functions] 1 243 1 CENTER BUS CONTROL When this button is on, the STEREO B channel will function as the CENTER channel. By adding the CENTER channel to the L/R channels of the STEREO A bus, you can implement threechannel playback. When this button is off, the CENTER channel signal will no longer be sent to STEREO B, meaning that it will not be output externally. (The same LR signal as STEREO A will be sent to STEREO B.) However even when the CENTER BUS CONTROL button is off, you can operate LCR pan for channels in which LCR mode is turned on. (When you turn the button on, the LCR setting will immediately take effect.) 2 LCR (LCR mode on/off) For each MIX channel, turn LCR mode on/off. In the case of channels for which LCR mode is turned on, the [PAN/BAL] encoder can be used to simultaneously control the level of the L/R channels and the CENTER channel if the [TO ST PAN] switch (located in the SELECTED OUTPUT CHANNEL output block of the CS1D top panel) is not turned on. Hint On channels for which LCR mode on, rotating the [PAN/BAL] encoder will cause the perimeter LEDs to light as follows. 112