Yamaha CS1D Owner's Manual - Page 16

CS1D Operating Manual (Start-up) Connecting an analog input/output unit to the engine (Standard mode) The following diagram shows a common way of making connections between the engine and analog input/output units for Standard mode. 1 INPUT 2 INPUT 1 ENGINE A (DSP1D-EX{DSP1D}) 2 OUTPUT 2 OUTPUT 1 OUTPUT A AI8 (ID=2) ANALOG INPUT BOX CONTROL PORT Switch = A OUTPUT A AI8 (ID=1) ANALOG INPUT BOX CONTROL PORT Switch = A 1 Analog input unit AI8 connection Connect the OUTPUT A connector of the AI8 analog input unit to one of the INPUT 1-INPUT 10 connectors of the engine. Set the CONTROL PORT switch (located on the rear panel of the AI8) to the A position. 2 Analog output unit AO8 connection Connect the INPUT A connector of the AO8 analog output unit to one of the OUTPUT 1-OUTPUT 6 connectors of the engine. Set the INPUT SELECTOR switch (located on the front panel of the AO8) to the A position. Hint An AI8 analog input unit can be connected to any INPUT connector of the engine, and the number of that INPUT connector will be the ID number of that unit. Similarly, an AO8 analog output unit can be connected to any OUTPUT connector of the engine, and the number of that OUTPUT connector will be the ID number of that unit. Be careful not to connect inputs and outputs in reverse. If such a connection is made, the unit will not be recognized and cannot be controlled. INPUT A AO8 (ID=1) ANALOG OUTPUT BOX INPUT SELECTOR Switch = A INPUT A AO8 (ID=2) ANALOG OUTPUT BOX INPUT SELECTOR Switch = A 8