Yamaha CS1D Owner's Manual - Page 302
MONITOR B TR IN 1] switch, ST A] switch, MONITOR A] switch, DEFINE] switch
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 302 highlights
MONITOR B section This section selects the monitor source for the MONITOR B output, and adjusts its level. MASTER block 1 SOURCE 2 3 4 1 MONITOR B SOURCE [2TR IN 1]/[2TR IN 2]/[ST A]/[ST B]/[MONITOR A]/[DEFINE] switches and LEDs These switches select the monitor source for the MONITOR B outputs. The switch LED for the currently selected source will light. (It is not possible to select two or more sources.) Each switch corresponds to the following sources. • [2TR IN 1] switch Monitor the input signal from the 2-TRACK IN DIGITAL 1 jack or 2-TRACK IN ANALOG 1 jacks located on the rear panel of the CS1D. The choice between analog and digital is made in the display (MON/CUE function 2TR IN screen). • [2TR IN 2] switch Monitor the input signal from the 2-TRACK IN DIGITAL 2 jack or 2-TRACK IN ANALOG 2 jacks located on the rear panel of the CS1D. The choice between analog and digital is made in the display (MON/CUE function 2TR IN screen). • [ST A] switch Monitor the output signal of the STEREO A channel. • [ST B] switch Monitor the output signal of the STEREO B channel. • [MONITOR A] switch Monitor the signal that is selected as the monitor source by the MONITOR A section. If this switch is selected, the CUE bus can also be monitored by the MONITOR B section. • [DEFINE] switch Monitor the signal (MIX 1-48, MATRIX 1-24, 2TR IN 3-6, or DIRECT IN) that was previously defined by the user in the display (MON/CUE function MONITOR B screen). 2 MONITOR B [LEVEL] volume This is an analog volume that sets the MONITOR B output level. Hint The value of this level cannot be stored in a scene or controlled from outside (or by the internal software). 85