Yamaha CS1D Owner's Manual - Page 52

CS1D Operating Manual (Start-up) Send the input signals of input channels 1/2 to the STEREO bus With the operations you have performed up to this point, the signals of the STEREO bus of the PM1D system will be output to the output jacks to which your monitor system is connected. Now we will send the signals of the input source to the STEREO bus to verify that they can be monitored via your monitor system. [Procedure] 1. Play back the input source. In INPUT block 1 of the console, verify that the meter LEDs light for input channels 1/49 and 2/50. INPUT block 1 PAN L TO ST R +48V INS A B INPUT PAN L TO ST R +48V INS A B INPUT GAIN +10 -68 CLIP + THR COMP GAIN +10 -68 CLIP + THR COMP + THR SEL GATE + THR SEL GATE [TO ST] switch [GAIN] encoder [ON] switch 2. If the input source is connected to a mic/line input card (LMY2-ML), adjust the [GAIN] encoder so that the CLIP segment of the meter LED does not light. 3. Turn on the [ON] switches of input channels 1/49 and 2/50 (so that the LEDs are lit). 4. Turn on the [TO ST] switches of input channels 1/ 49 and 2/50. 5. Raise the faders of input channels 1/49 and 2/50 to the 0 position (nominal level). 6. In the STEREO OUTPUT block, turn on the STEREO [ON] switch of the ST OUTPUT A channel. STEREO OUTPUT block ON CLIP 6 12 18 30 60 ON CLIP 6 12 18 30 60 50 50 60 60 CUE CUE Meter LEDs for input channels 1/49 and 2/50 [CUE] switch STEREO [ON] switch of the ST OUTPUT A channel Fader ON TO MTRX M SEL INS 10 5 0 5 10 20 RCL 30 MUTE SAFE 40 50 60 CUE ST OUTPUT ST A 44