Yamaha CS1D Owner's Manual - Page 276

DELAY section In this section you can make settings for the internal delay function. 1 2 SELECTED OUTPUT CHANNEL block ON msec TIME DELAY 1 DELAY [ON] switch and LED This is the on/off switch for the delay of the selected channel. When this is on, the switch LED will light, and the input signal will be delayed by the delay time shown in the DELAY TIME [VALUE] indicator (2). 2 DELAY [TIME] encoder and [VALUE] indicator The DELAY [TIME] encoder sets the delay time of the selected output channel. The current delay time will be displayed in the DELAY TIME [VALUE] indicator in millisecond units. The delay time range is 0 msec - 1000 msec Hint The output channel delay function provides a useful way to compensate for time differences between speakers placed at distant locations. Even if the internal clock on which the PM1D system operates is switched from 48 kHz to 44.1 kHz (or the opposite), the delay time will not change. However while a PM1D system is synchronized to a word clock supplied from an external device, the displayed time and the actual delay time may differ if the word clock frequency is changed using vari-pitch. If you have selected one channel of two paired MIX/MATRIX channels, or the L or R channel of a STEREO channel, the parameters of the DELAY section can be set independently for each channel. If you adjust the delay time here, decimal places that are not subsequently displayed will be rounded off. 59