Yamaha CS1D Owner's Manual - Page 97
Sending a signal from an input channel to a STEREO bus, REO A [ON] or STEREO B [ON] switch.
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
CS1D Operating Manual (Basic Operation) Sending a signal from an input channel to a STEREO bus Here's how to use the INPUT block/ST IN block to send an input channel signal to a STEREO bus. Hint The procedure described here uses the example of an input channel, but virtually the same procedure applies to ST IN channels as well. [Procedure] 1. Make sure that an input source is correctly patched to the input channel, and that the head amp is set appropriately. 2. In the INPUT block, turn on the INPUT [ON] switch. 3. Turn on the INPUT [TO ST] switch. 4. Raise the INPUT fader. The input channel signal will now be sent to the STEREO buses. 6. In the STEREO OUTPUT block, turn on the STEREO A [ON] or STEREO B [ON] switch. The STEREO OUTPUT block is where signals sent to the STEREO bus are output via the STEREO A/B channels to an output unit. Hint If the PM1D system is in its initial state, the STEREO A/STEREO B section of the meter bridge block will show the level of the signals sent to the STEREO bus (the pre-attenuator level of STEREO A/B channels). 5. As necessary, use the INPUT [PAN] encoder to adjust the panning of the signal. The peripheral LEDs will indicate the approximate current value. If the ▲ LED is lit, this indicates that the signal is panned to the center. When sending signals from a ST IN channel to the STEREO bus, use the ST IN SEL [L]/[R] switches to select each channel separately, and set the ST IN [PAN] encoder separately for L and R. STEREO OUTPUT block STEREO A [ON] switch ON ON TO MTRX MONO SEL SEL STEREO B [ON] switch INS 10 5 0 5 10 20 RCL 30 MUTE SAFE 40 50 60 INS 10 5 0 5 10 20 RCL 30 MUTE SAFE 40 50 60 STEREO A/ STEREO B faders 7. In the STEREO OUTPUT block, raise the STEREO A or STEREO B fader. The signal sent from the input channel to the STEREO bus will be output from the output jack(s) patched to the STEREO A or STEREO B channel. 38