Yamaha CS1D Owner's Manual - Page 300
MONITOR A TR IN 1] switch, ST A] switch, DEFINE] switch
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 300 highlights
MONITOR A section This section selects the monitor source for the MONITOR A output, and adjusts its level. MASTER block 1 2 SOURCE 3 DELAY 4 5 6 7 1 MONITOR A SOURCE [2TR IN 1]/[2TR IN 2]/[ST A]/[ST B]/[DEFINE] switches and LEDs These switches select the monitor source for the MONITOR A outputs. The switch LED for the currently selected source will light. (It is not possible to select two or more sources.) Each switch corresponds to the following sources. • [2TR IN 1] switch Monitor the input signal from the 2-TRACK IN DIGITAL 1 jack or 2-TRACK IN ANALOG 1 jacks located on the rear panel of the CS1D. The choice between analog and digital is made in the display (MON/CUE function 2TR IN screen). • [2TR IN 2] switch Monitor the input signal from the 2-TRACK IN DIGITAL 2 jack or 2-TRACK IN ANALOG 2 jacks located on the rear panel of the CS1D. The choice between analog and digital is made in the display (MON/CUE function 2TR IN screen). • [ST A] switch Monitor the output signal of the STEREO A channel. • [ST B] switch Monitor the output signal of the STEREO B channel. • [DEFINE] switch Monitor the signal (MIX 1-48 , MATRIX 1-24 , 2TR IN 3-6, or DIRECT IN) that was previously defined by the user in the display (MON/CUE function MONITOR A screen). Hint With the default state of the PM1D, the setting of the MONITOR A SOURCE switches will be ignored if even one [CUE] switch is on, and the cue (solo) signal will be output from the MONITOR OUT A jacks/MONITOR A phones jack. However, you can make settings so that the state of the [CUE] switches will be ignored and the source selected by the MONITOR A SOURCE switch will always be output from the MONITOR OUT A jacks. This setting is made in the display (MON/CUE function MONITOR A screen). 83