Yamaha CS1D Owner's Manual - Page 199

CS1D Operating Manual (Basic Operation) 3. In the MIDI PORT section of the screen, press the button for the port at which program changes will be transmitted and received. In the MIDI PORT section you can select from the following ports to transmit (TX) and receive (RX) MIDI program change messages. • CONSOLE ..........MIDI IN/OUT connectors on the rear panel of the console • ENGINE A ..........MIDI IN/OUT connectors of engine A • ENGINE B ..........MIDI IN/OUT connectors of engine B • OFF MIDI messages will not be transmitted or received Hint DSPx2 The ENGINE B button is valid only when the PM1D system is being used in Mirror mode. 4. In the MIDI MODE section, use the MULTI or SINGLE button to select the program change transmission/reception mode. You can select one of the following two modes. • Single mode (when the SINGLE button is on) This mode uses a single MIDI channel to transmit and receive programs. In this mode, incoming program changes 1-128 received on the MIDI channel specified by the RX CH knob (RX CH) will execute the event assigned to each program number. When the corresponding events are executed on the CS1D, a program change 1-128 will be transmitted to the external device on the MIDI channel specified by the TX CH knob (TX CH). • Multi mode (when the MULTI button is on) This mode uses multiple MIDI channels to transmit and receive program changes. In this mode, incoming program changes 1-128 on MIDI channels 1-16 will execute the event assigned to each program MIDI channel/program number. When the corresponding events are executed on the CS1D, a program change 1-128 will be transmitted to the external device on a MIDI channel 1-16. 5. If you selected single mode in step 4, use the TX CH/RX CH knobs to select the MIDI channels on which program changes will be transmitted or received. If desired, turn on the OMNI button or the BANK button. When Single mode is selected, turning the OMNI button on will allow program change messages of all MIDI channels to be received. When Single mode is selected, turning the BANK button on will allow events to be specified by the combination of bank select messages (bank numbers 1-16) + program change messages. Please do not confuse "Single mode/OMNI button on" with "Multi mode." When the OMNI button is on, program changes will be received on all MIDI channels, but the only events that can be executed are those that have been assigned to program changes 1-128 of the RX CH. Also, the TX CH is the only MIDI channel that can be transmitted. 6. From the PROGRAM CHANGE EVENT list in the right of the screen, select the program number to which you wish to assign an event, and click the button of that line. The PROGRAM CHANGE EVENT list allows you to assign an event to each program number. When you click the button of the desired line, a popup window will appear, where you can select an event to assign. • Event selection popup window Hint In Multi mode, MIDI channels 1-16 and program changes 1-128 can be used. In Single mode, only program changes 1-128 of the MIDI channel selected by the RX CH knob can be used. If the BANK button is turned on in Single mode, bank select 1-16 and program change 1-128 of the MIDI channel selected by the RX CH knob can be used. In this case, the number displayed in the CH column of the PROGRAM CHANGE EVENT list will be the bank number. 7. Click one of the buttons in the upper left of the window to select the type of event. The following events can be selected. • SCENE Scene memory recall operations • EFFECT Effect recall operations • NO ASSIGN....... No event assigned 8. If you selected Scene memory recall in step 7, select the number of the desired scene from the list in the right side of the popup window, and click the OK button. 140