Yamaha CS1D Owner's Manual - Page 250

SELECTED INPUT CHANNEL block DCA section This section assigns the currently selected channel to a DCA group. It is convenient to use this section when you wish to assign a single channel to multiple DCA groups. 1 2 3 4 5 6 1 7 8 1 DCA [1]-[12] switches and LEDs These switches assign the currently selected channel to DCA groups 1-12. When the channel is assigned to a DCA group, the LED of the corresponding switch will light. 9 10 11 12 DCA [Procedure] Using the SELECTED INPUT CHANNEL block to assign a channel to a DCA group 1. Select the input channel or ST IN channel that you wish to assign to a DCA group (1-12). 2. In the SELECTED INPUT CHANNEL block, use the DCA [1]-[12] switches to select the DCA group(s) to which you wish to assign the channel. (You may select more than one DCA group.) The LED(s) for the corresponding DCA group(s) will light. • DCA groups 9-12 can be used for either input channels or output channels. However, it is not possible to assign both inputs and outputs to the same DCA group. For this reason, if an output channel is already assigned to DCA group 9-12, attempting to assign an input channel will cause a message to be displayed, and you will not be able to do so. • When a scene is recalled, the DCA group data of recall safe channels may be adjusted so that recall safe settings are consistent within DCA groups 9-12. Also when a channel library is recalled, the data recalled to a channel may be adjusted so that settings are consistent within DCA groups 9-12. 33