Yamaha CS1D Owner's Manual - Page 249
FADER CLIP [EQ] LED, CLIP [CH, ON] switch and LED, Fader, Meter LEDs, PRE ATT, PRE FADER
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 249 highlights
CS1D Reference Manual (Hardware) FADER section In this section you can switch the currently selected channel on/off, and set its input level. 2 1 3 ON 5 4 1 CLIP [EQ] LED This LED will light when the post-EQ signal clips. If this LED lights, lower the [ATTENUATOR] encoder. 2 CLIP [CH ∑] LED This LED will light if clipping occurs at any of the following locations: the currently selected channel metering point, PRE ATT, POST EQ, POST GATE, POST COMP, or INSERT IN. The lit state of this LED will be held if input PEAK HOLD is turned on in the METER function screen. 3 [ON] switch and LED This turns the currently selected channel on/off. (The LED will light for an input channel that is turned on.) If this switch is turned off, no signals will be sent from that channel to the STEREO bus or MIX buses. 4 Fader This is a 100 mm fader that adjusts the input level of the currently selected channel. The range is - ∞ - +10 dB. 32 6 5 Meter LEDs This is a twelve-point LED meter that indicates the input level of the channel. The position at which the level is detected can be selected from the following locations: • PRE ATT Before the attenuator • PRE GATE ...........Immediately before the internal gate • PRE FADER ....... Immediately before the fader • POST FADER .... Immediately after the fader • POST ON Immediately after the [ON] switch The level detection point can be selected in the display (METER function). 6 [CUE] switch and LED This switch monitors the currently selected channel. When this switch is pressed, the POST PAN, PFL (pre-fader listen), or AFL (after-fader listen) signal of the corresponding channel will be sent to the CUE bus, and can be monitored from the CUE OUT jacks, MONITOR OUT jacks A, and PHONES jack. The position of the signal sent to the CUE bus and the monitoring method can be selected from the console in the MASTER block CUE section, or in the display (MON/CUE function CUE/SOLO screen).