Yamaha CS1D Owner's Manual - Page 177
the mode of operation when two or more [CUE], switches within the same group are pressed.
![]() |
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
CS1D Operating Manual (Basic Operation) 3. Use the [INPUT AFL] switch located in the CUE section of the MASTER block to specify the position from which the signal will be sent to the CUE bus when the [CUE] switch of an input channel is pressed. When the [INPUT AFL] switch is off, the post-fader signal will be sent to the CUE bus. When this switch is on, the pre-fader signal will be sent. 4. Use the [OUTPUT PFL] switch of the CUE section to specify the position from which the signal will be sent to the CUE bus when the [CUE] switch of an output channel is pressed. When the [OUTPUT PFL] switch is off, the prefader signal will be sent to the CUE bus. When this switch is on, the post-fader signal will be sent. 5. Use the [DCA PRE PAN] switch of the CUE section to specify the position from which the signal will be sent to the CUE bus when the [CUE] switch of a DCA group is pressed. When the [DCA PRE PAN] switch is off, the postpan signal will be sent to the CUE bus. When the switch is on, the pre-pan signal will be sent. Hint The setting of this switch only affects DCA groups to which input channels are assigned. For DCA groups to which output channels are assigned, the signal will always be sent to the CUE bus from a location immediately after the [ON] switch. 6. Use the [LAST CUE] switch of the CUE section to select either LAST CUE mode ([LAST CUE] switch on) or MIX CUE mode ([LAST CUE] switch off) as the mode of operation when two or more [CUE] switches within the same group are pressed. The operation of the two modes differs as follows. • LAST CUE mode ([LAST CUE] switch is on) Only the channel/DCA group whose [CUE] switch was pressed last will be monitored. Hint In LAST CUE mode, pressing the [CUE] switch of a channel will also cause the [SEL] switch to operate in tandem, selecting that channel. • MIX CUE mode ([LAST CUE] switch is off) All channels/DCA groups within the same cue group whose [CUE] switches are on will be monitored. Hint It is not possible to simultaneously turn on [CUE] switches that belong to different groups. The group to which the last-pressed [CUE] switch belongs will take priority, and the signals of that group can be monitored. In this case of channels that are paired, both channels will be turned on. 7. Make sure that the [SOLO] switch of the CUE section is off (Cue mode). 8. Turn on the [CUE] switch of the desired channel/ DCA group. The cue signal of the corresponding channel will be output from MONITOR OUT jacks A, the PHONES MONITOR A jack, and the CUE OUT jacks. 9. To defeat cue, press the currently-on [CUE] switch(es) once again. Hint When you press the [LAST CUE] switch to change from LAST CUE mode to MIX CUE mode (or vice versa), the previously-valid cue (solo) will be cancelled. 118
![](/manual_guide/products/yamaha-cs1d-owners-manual-4920b31/177.png)