Yamaha CS1D Owner's Manual - Page 436

OUT INSERT OUT PATCH OUT DCA/MUTE (output DCA/mute) function OUT DCA/MUTE (output DCA/mute) function Set DCA and mute group settings for the output channels DCA ASSIGN [Function] Assign output channels to DCA faders 9-12 and operate the DCA faders 9-12. ■ Console In the LCD FUNCTION ACCESS block, press the OUTPUT [DCA/ MUTE] (press repeatedly until the screen shown at the right appears) ■ Display MENU button → OUTPUT DCA/ MUTE button → DCA ASSIGN tab OUT EQ OUT CH VIEW MATRIX/ST OUT DCA/MUTE OUT DELAY OUT COMP [Screen functions] 1 2 3 1 These are the DCA group numbers. The number corresponding to the grid where the cursor is currently located will be highlighted. Only DCA faders 9-12 can be assigned to output channels. 2 These are the eight-character names displayed in the DCA fader section. You can also click here and modify the names of the DCA faders. 3 Grid In this grid you can assign output channels (horizontal lines) to DCA faders (vertical columns. Currentlypatched grids will be indicated by a ● symbol. Move the cursor to the desired grid, and press the [ENTER] switch (or click) to set/cancel an assignment. Hint You can also use multiple DCA control by assigning a single output channel to more than one DCA fader. • DCA faders 9-12 can be used for either input channels or output channels. However, it is not possible to assign both input and output channels to the same DCA fader. For this reason, if an input channel is already assigned to a DCA fader 9-12, it will not be possible to assign an output channel to the same DCA fader. 101