Yamaha CS1D Owner's Manual - Page 45
MONITOR OUT jacks A or the MONITOR A, LED go dark. CS1D Reference Manual Hard
View all Yamaha CS1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Checking the operation of input units Hint When monitoring through the MONITOR A headphone jack, raise the MONITOR A PHONES [LEVEL] volume (located in the MONITOR A section of the MASTER block) to an appropriate level. If you are now able to monitor the signal, you have verified that the input unit/card to which the source is connected is operating normally. 4. As necessary, perform the same operational check for other input units or cards. If you are unable to monitor an input source, check the following points. Meter LEDs of the INPUT block do not light • Is the input source connected appropriately? → Check the unit/card to which the input source is connected (→p.32) • When using a mic/line input card (LMY2-ML), is the input source connected to input jacks 1A and 2A? → When the PM1D system is in the default state, input jacks 1B or 2B cannot be used without changing the settings. Re-connect to input jacks 1A and 2A (→p.32). • Has the input unit/card to which the input source is connected been correctly patched to the input channel? → Check the settings of the IN PATCH screen (→p.33). • In the SELECTED INPUT CHANNEL block, has the MODULE [FLIP] switch been turned on (LED lit)? → When the MODULE [FLIP] switch is on, the modules of INPUT blocks 1 and 2 will be exchanged. Press the MODULE [FLIP] switch to make the LED go dark. ("CS1D Reference Manual (Hardware)" →p.5) • In the MASTER block GLOBAL LAYER section, has the [49-96] switch been turned on (LED lit)? → On the 96 channel model when the GLOBAL LAYER [49-96] switch is on (LED lit), channels 49-96 will be selected as the input channels that are controlled from the top panel of the CS1D. {This switch has no function on the 48 channel model.} To control channels 1-48, press the GLOBAL LAYER [1-48] switch. ("CS1D Reference Manual (Hardware)" →p.5) Meter LEDs of the INPUT block do light, but the signal is not output from MONITOR OUT jacks A or the MONITOR A headphone jack • Is your monitor system connected appropriately? → Check the connections of the monitor system/ headphones. • Is the monitor volume raised? → Raise the MONITOR A [LEVEL] or [PHONES] volume to an appropriate level. • In the MASTER block CUE section, have the [SOLO], [INPUT AFL], or [LAST CUE] switches been turned off? → If any of these switches are on, it may not be possible for the signal of the input channel whose [CUE] switch was pressed to be monitored from MONITOR OUT jacks A or the MONITOR A headphone jack. You must turn off all of these switches. ("CS1D Reference Manual (Hardware)" →p.81) The meter LEDs of the INPUT block are lit, and a signal is output from the MONITOR A headphone jack, but no signal is output from MONITOR OUT jacks A • Is the CUE INTERRUPTION button (MON/CUE function MONITOR A screen) turned on? → Monitoring is not possible if the CUE INTERRUPTION button is turned off. Turn this button on. ("CS1D Reference Manual (Software)" →p.71) 37