Cisco N7K-C7010 Configuration Guide - Page 100

Configuring Access and Trunk Interfaces Chapter 3 Configuring Layer 2 Interfaces Send document comments to [email protected] SUMMARY STEPS 1. configure terminal 2. default interface int-if [checkpoint name] 3. exit 4. (Optional) show interface DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal switch(config)# default interface int-if [checkpoint name] Example: switch(config)# default interface ethernet 3/1 checkpoint test8 Step 3 exit Step 4 Example: switch(config)# exit switch# show interface Example: switch# show interface Purpose Enters configuration mode. Deletes the configuration of the interface and restores the default configuration. Use the ? keyword to display the supported interfaces. Use the checkpoint keyword to store a copy of the running configuration of the interface before clearing the configuration. Exits the configuration mode. (Optional) Displays the interface status and information. This example shows how to delete the configuration of an Ethernet interface while saving a checkpoint of the running configuration for rollback purposes: switch# configure terminal switch(config)# default interface ethernet 3/1 checkpoint test8 .......Done switch(config)# Configuring SVI Autostate Exclude You can configure the SVI Autostate Exclude feature on an Ethernet interface or a port channel. You can use the Autostate Exclude option to enable or disable the port from bringing up or down the SVI calculation and applying it to all VLANs that are enabled on the selected port. SUMMARY STEPS 1. configure terminal 2. interface {{type slot/port} | {port-channel number}} 3-18 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x OL-23435-03