Cisco N7K-C7010 Configuration Guide - Page 289
Configuring the Rate Limit for Layer 2 Protocol Tunnel Ports
UPC - 882658174445
View all Cisco N7K-C7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 289 highlights
Chapter 9 Configuring Q-in-Q VLAN Tunnels Configuring Q-in-Q Tunnels and Layer 2 Protocol Tunneling Send document comments to [email protected] DETAILED STEPS Step 1 Command configure terminal Purpose Enters global configuration mode. Step 2 Example: switch# configure terminal l2protocol tunnel cos cos-value Step 3 Example: switch(config)# l2protocol tunnel cos 6 no l2protocol tunnel cos Specifies a global CoS value on all Layer 2 protocol tunneling ports. The default cos-value is 5. (Optional) Sets the global CoS value to default. Step 4 Example: switch(config)# no l2protocol tunnel cos exit Exits configuration mode. Step 5 Example: switch(config)# exit copy running-config startup-config (Optional) Copies the running configuration to the Example: startup configuration. switch# copy running-config startup-config This example shows how to specify a global CoS value for the purpose of Layer 2 protocol tunneling: switch# configure terminal switch(config)# l2protocol tunnel cos 6 switch(config)# exit Configuring the Rate Limit for Layer 2 Protocol Tunnel Ports You can specify the hardware rate limiter configuration for Layer 2 protocol tunneling. The default is set to 500 packets per second. Depending on the load or the number of VLANs to be tunneled for a customer, you may need to adjust this value to prevent STP errors on the customer's network. SUMMARY STEPS 1. configure terminal 2. hardware rate-limiter layer-2 l2pt packets-per-sec 3. no hardware rate-limiter layer-2 l2pt OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 9-13