Cisco N7K-C7010 Configuration Guide - Page 44
Sharing the Bandwidth Among a Port Group, BEFORE YOU BEGIN, SUMMARY STEPS
UPC - 882658174445
View all Cisco N7K-C7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Configuring the Basic Interface Parameters Chapter 2 Configuring Basic Interface Parameters Send document comments to [email protected] Step 4 Command interface ethernet slot/port Step 5 Example: switch(config)# interface ethernet 3/1 switch(config)# rate-mode dedicated Step 6 Example: switch(config-if)# rate-mode dedicated switch(config-if)# no shutdown Purpose Specifies the first Ethernet interface in a group of interfaces. Dedicates the full bandwidth of 10 Gb to one port. When you dedicate the bandwidth, all subsequent commands for the port are for dedicated mode. Brings the port administratively up. Step 7 Example: switch(config-if)# no shutdown show interface ethernet slot/port capabilities Step 8 Example: switch(config)# show interface ethernet 3/1 exit Displays the interface information including the current rate mode. Exits the interface mode. Step 9 Example: switch(config-if)# exit switch(config)# copy running-config startup-config (Optional) Copies the running Example: configuration to the startup configuration. switch(config)# copy running-config startup-config This example shows how to configure the dedicated mode for Ethernet port 4/17 in the group that includes ports 4/17, 4/19, 4/21, and 4/23: switch# configure terminal switch(config)# interface ethernet 4/17, ethernet 4/19, ethernet 4/21, ethernet 4/23 switch(config-if)# shutdown switch(config-if)# interface ethernet 4/17 switch(config-if)# rate-mode dedicated switch(config-if)# no shutdown switch(config-if)# Sharing the Bandwidth Among a Port Group You can share 10 Gb of bandwidth among a group of ports (four ports) on a 32-port 10-Gigabit Ethernet module. To share the bandwidth, you must bring the dedicated port administratively down, specify the ports that are to share the bandwidth, change the rate mode to shared, and then bring the ports administratively up. BEFORE YOU BEGIN All ports in the same group must belong to the same VDC. SUMMARY STEPS 1. configure terminal 2. interface ethernet slot/port 2-20 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x OL-23435-03