Cisco N7K-C7010 Configuration Guide - Page 253
Optional Displays information about the vPC, Exits the vpc-domain configuration mode.
UPC - 882658174445
View all Cisco N7K-C7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
Chapter 7 Configuring vPCs Configuring vPCs Send document comments to [email protected] DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal switch(config)# vpc domain domain-id Step 3 Example: switch(config)# vpc domain 5 switch(config-vpc-domain)# auto-recovery [reload-delay time] Example: switch(config-vpc-domain)# auto-recovery Step 4 exit Example: switch(config-vpc-domain)# exit switch(config)# Purpose Enters global configuration mode. Enters the vPC domain number that you want to configure. The system enters the vpc-domain configuration mode. Configures the vPC to assume its peer is not functional and to bring up the vPC, and specifies the time to wait after reload to restore the vPC. The default delay is 240 seconds. You can configure a delay from 240 to 3600 seconds. Use the no form of the command to reset the vPC to the standard behavior. Exits the vpc-domain configuration mode. Step 5 Step 6 Step 7 show running-config vpc Example: switch# show running-config vpc show vpc consistency-parameters interface port-channel number (Optional) Displays information about the vPC, specifically the reload status. (Optional) Displays information about the vPC consistency parameters for the specified interface. Example: switch# show vpc consistency-parameters interface port-channel 1 copy running-config startup-config Example: switch# copy running-config startup-config (Optional) Copies the running configuration to the startup configuration. Note To ensure the autorecovery feature is enabled, you should perform this step. This example shows how to set the vPC autorecovery feature and save it in the switch startup configuration: switch# configure terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# vpc domain 5 switch(config-vpc-domain)# auto-recovery Warning: Enables restoring of vPCs in a peer-detached state after reload, will wait for 240 seconds to determine if peer is un-reachable switch(config-vpc-domain)# exit switch(config)# exit switch# copy running-config startup-config OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 7-51