Cisco N7K-C7010 Configuration Guide - Page 42

Configuring the Basic Interface Parameters Chapter 2 Configuring Basic Interface Parameters Send document comments to [email protected] 3. {beacon | no beacon} 4. show interface ethernet slot/port 5. exit 6. copy running-config startup-config DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal switch(config)# interface ethernet slot/port Step 3 Example: switch(config)# interface ethernet 3/1 switch(config-if)# {beacon | no beacon} Step 4 Example: switch(config-if)# beacon switch(config-if)# show interface ethernet slot/port Step 5 Example: switch(config)# show interface ethernet 2/1 exit Step 6 Example: switch(config-if)# exit switch(config)# copy running-config startup-config Example: switch(config)# copy running-config startup-config Purpose Enters configuration mode. Specifies an interface to configure, and enters interface configuration mode. Enables the beacon mode or disables the beacon mode. The default mode is disabled. Displays the interface status, which includes the beacon mode state. Exits the interface mode. (Optional) Copies the running configuration to the startup configuration. This example shows how to enable the beacon mode for the Ethernet port 3/1: switch# configure terminal switch(config)# interface ethernet 3/1 switch(config-if)# beacon switch(config-if)# This example shows how to disable the beacon mode for the Ethernet port 3/1: switch# configure terminal switch(config)# interface ethernet 3/1 switch(config-if)# no beacon switch(config-if)# 2-18 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x OL-23435-03