Cisco N7K-C7010 Configuration Guide - Page 49

Chapter 2 Configuring Basic Interface Parameters Configuring the Basic Interface Parameters Send document comments to [email protected] DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal switch(config)# errdisable recovery interval interval Example: switch(config)# errdisable recovery interval 32 switch(config-if)# Step 3 show interface status err-disabled Step 4 Example: switch(config)# show interface status err-disabled copy running-config startup-config Example: switch(config)# copy running-config startup-config Purpose Enters configuration mode. Specifies the interval for the interface to recover from the error-disabled state. The range is from 30 to 65535 seconds, and the default is 300 seconds. Displays information about error-disabled interfaces. (Optional) Copies the running configuration to the startup configuration. This example shows how to configure the error-disabled recovery timer to set the interval for recovery to 32 seconds: switch(config)# errdisable recovery interval 32 switch(config)# Configuring the MDIX Parameter If you need to detect the type of connection (crossover or straight) with another copper Ethernet port, enable the medium dependent independent crossover (MDIX) parameter for the local port. By default, this parameter is enabled. BEFORE YOU BEGIN You must enable MDIX for the remote port. SUMMARY STEPS 1. configure terminal 2. interface ethernet slot/port 3. {mdix auto} | {no mdix} 4. show interface ethernet slot/port 5. exit 6. copy running-config startup-config OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 2-25