Cisco N7K-C7010 Configuration Guide - Page 287
Enabling the Layer 2 Protocol Tunnel, interface ethernet
UPC - 882658174445
View all Cisco N7K-C7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 287 highlights
Chapter 9 Configuring Q-in-Q VLAN Tunnels Configuring Q-in-Q Tunnels and Layer 2 Protocol Tunneling Send document comments to [email protected] Command Step 6 exit Purpose Exits configuration mode. Step 7 Example: switch(config-if)# exit switch(config)# exit copy running-config startup-config (Optional) Copies the running configuration to the Example: startup configuration. switch# copy running-config startup-config This example shows how to create an 802.1Q tunnel port: switch# configure terminal switch(config)# interface ethernet 7/1 switch(config-if)# switchport switch(config-if)# switchport dot1q ethertype 0x9100 switch(config-if)# exit switch(config)# exit switch# show dot1q-tunnel Enabling the Layer 2 Protocol Tunnel You can enable protocol tunneling on the 802.1Q tunnel port. SUMMARY STEPS 1. configure terminal 2. interface ethernet slot/port 3. switchport 4. switchport mode dot1q-tunnel 5. l2protocol tunnel [cdp | stp | vtp] 6. no l2protocol tunnel [cdp | stp | vtp] 7. exit 8. copy running-config startup-config DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal interface ethernet slot/port Example: switch(config)# interface ethernet 7/1 Purpose Enters global configuration mode. Specifies an interface to configure, and enters interface configuration mode. OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 9-11