Cisco N7K-C7010 Configuration Guide - Page 242

Configuring vPCs Chapter 7 Configuring vPCs Send document comments to [email protected] 3. graceful consistency-check 4. exit 5. (Optional) show vpc brief DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal switch(config)# vpc domain domain-id Step 3 Example: switch(config-if)# vpc domain 5 switch(config-vpc-domain)# graceful consistency-check Example: switch(config-vpc-domain)# graceful consistency-check Step 4 exit Step 5 Example: switch(config-vpc-domain)# exit switch(config)# show vpc brief Example: switch# show vpc brief Purpose Enters global configuration mode. Creates a vPC domain if it does not already exist, and enters the vpc-domain configuration mode. Specifies that only the links on the secondary peer device are suspended when a mismatch is detected in a mandatory compatibility parameter. Use the no form of this command to disable the feature. Exits the vpc-domain configuration mode. (Optional) Displays information on the vPCs. This example shows how to enable the graceful consistency check feature: switch# configure terminal switch(config)# vpc domain 5 switch(config-vpc-domain)# graceful consistency-check Checking the Configuration Compatibility on a vPC Peer Link After you have configured the vPC peer link on both vPC peer devices, check that the configurations are consistent on all vPC interfaces. See the "Compatibility Parameters for vPC Interfaces" section on page 7-15 for information on consistent configurations on the vPCs. SUMMARY STEPS 1. configure terminal 2. (Optional) show vpc consistency-parameters {global | interface port-channel channel-number} 7-40 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x OL-23435-03