Cisco N7K-C7010 Configuration Guide - Page 186

Configuring Port Channels Chapter 6 Configuring Port Channels Send document comments to [email protected] Step 2 Command feature lacp Step 3 Example: switch(config)# feature lacp copy running-config startup-config Example: switch(config)# copy running-config startup-config This example shows how to enable LACP: switch# configure terminal switch (config)# feature lacp Purpose Enables LACP on the device. (Optional) Copies the running configuration to the startup configuration. Configuring LACP Port-Channel Port Modes After you enable LACP, you can configure the channel mode for each individual link in the LACP port channel as active or passive. This channel configuration mode allows the link to operate with LACP. When you configure port channels with no associated aggregation protocol, all interfaces on both sides of the link remain in the on channel mode. BEFORE YOU BEGIN Ensure that you are in the correct VDC (or use the switchto vdc command). SUMMARY STEPS 1. configure terminal 2. interface type slot/port 3. channel-group number mode {active | on | passive} 4. show port-channel summary 5. copy running-config startup-config DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal switch(config)# interface type slot/port Example: switch(config)# interface ethernet 1/4 switch(config-if) Purpose Enters configuration mode. Specifies the interface to configure, and enters the interface configuration mode. 6-30 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x OL-23435-03