Cisco N7K-C7010 Configuration Guide - Page 43

Chapter 2 Configuring Basic Interface Parameters Configuring the Basic Interface Parameters Send document comments to [email protected] Changing the Bandwidth-Rate Mode You can specify whether each 10 Gb of bandwidth on a 32-port 10-Gigabit Ethernet module is dedicated to one port or shared by four ports in the same port group. This section includes the following topics: • Creating a Port Profile, page 2-43 • Sharing the Bandwidth Among a Port Group, page 2-20 Dedicating Bandwidth to One Port When you dedicate the bandwidth to one port, you must first administratively shut down the four ports in the group, change the rate mode to dedicated, and then bring the dedicated port administratively up. SUMMARY STEPS 1. configure terminal 2. interface ethernet slot/port, ethernet slot/port, ethernet slot/port, ethernet slot/port 3. shutdown 4. interface ethernet slot/port 5. rate-mode dedicated 6. no shutdown 7. show interface ethernet slot/port capabilities 8. exit 9. copy running-config startup-config DETAILED STEPS Step 1 Command configure terminal Purpose Enters configuration mode. Step 2 Step 3 Example: switch# configure terminal switch(config)# interface ethernet slot/port, ethernet slot/port, ethernet slot/port, ethernet slot/port Example: switch(config)# interface ethernet 3/1, ethernet 3/3, ethernet 3/5, ethernet 3/7 switch(config-if)# shutdown Specifies an Ethernet interface to configure, and enters interface configuration mode. The example shows how to specify one port for the dedicated mode. Administratively shuts down the ports. Example: switch(config)# shutdown OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 2-19