Cisco N7K-C7010 Configuration Guide - Page 69
Assigning a Port Profile to a Range of Interfaces
UPC - 882658174445
View all Cisco N7K-C7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Chapter 2 Configuring Basic Interface Parameters Configuring the Basic Interface Parameters Send document comments to [email protected] DETAILED STEPS Step 1 Command configure terminal Purpose Enters configuration mode. Step 2 Example: switch# configure terminal switch(config)# port-profile [type {ethernet | interface-vlan | loopback | port channel | tunnel}] name Step 3 Example: switch(config)# port-profile type tunnel test switch(config-ppm)# no shutdown switch(config-ppm)# exit Enters the port-profile configuration mode for the specified port profile and allows you to add or remove configurations to the profile. Exits the port-profile configuration mode. Step 4 Step 5 Example: switch(config-ppm)# exit switch(config)# show port-profile Example: switch(config)# show port-profile (Optional) Displays the port-profile configuration. copy running-config startup-config (Optional) Copies the running Example: configuration to the startup configuration. switch(config)# copy running-config startup-config This example shows how to enter the port-profile configuration mode for the specified port profile and bring all the interfaces administratively up: switch# configure terminal switch(config)# port-profile type tunnel test switch(config-ppm)# no shutdown switch(config-ppm)# Assigning a Port Profile to a Range of Interfaces You can assign a port profile to an interface or to a range of interfaces. All the interfaces must be the same type. SUMMARY STEPS 1. configure terminal 2. interface [ethernet slot/port | interface-vlan vlan-id | loopback number | port-channel number | tunnel number] 3. inherit port-profile name 4. exit 5. show port-profile 6. copy running-config startup-config OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 2-45